Dripping taps can be a frustrating and wasteful problem. Fortunately, many dripping taps can be fixed by simply replacing the washer. This is a relatively easy DIY project that can save you money and prevent further water waste. In this step-by-step guide, we will walk you through the process to change tap washer.
Step by step guide to change tap water:
Step 1:
Turn off the water supply. Before starting any plumbing project, it is important to turn off the water supply to the affected area. This will prevent any water from flowing while you work and prevent further damage.
Step 2:
Remove the tap handle. Use a screwdriver to remove the screw or nut that is holding the tap handle in place. This may be located on top of the handle or underneath it.
Step 3:
Remove the tap bonnet. The bonnet is the cover that sits over the tap valve. Use pliers or a wrench to loosen and remove the bonnet.
Step 4:
Remove the old washer. The washer sits at the base of the valve stem. Use pliers to remove the old washer.
Step 5:
Install the new washer. Place the new washer in the same position as the old washer. It should fit snugly over the valve stem.
Step 6:
Reassemble the tap. Replace the bonnet and tap handle in the reverse order that you removed them. Make sure the screw or nut is tightened securely.
Step 7:
Turn on the water supply. Once you have reassembled the tap, turn on the water supply and check for leaks. If everything is working properly, the dripping should have stopped.
In conclusion, changing a tap washer is a simple DIY project that can save you money and prevent further water waste. While the process may vary slightly depending on the type of tap you have, these basic steps will help guide you through the process. As always, if you are unsure or uncomfortable with any aspect of the project, it is best to consult with a licensed plumbing professional.